Fabriglaze 25% Wet Look
Fabriglaze 25% Wet Look
FABRIGLAZE® SB-25 is designed for use on concrete requiring a “wet look” high-gloss finish. It is formulated to 25% solids.
APPLICATION
Thoroughly test surfaces to be treated to ensure compatibility. Apply material as
supplied. Preferred method of application is by low pressure spray, however brush or
roller are suitable where necessary. Apply FABRIGLAZE® in a uniform manner. It is
recommended that FABRIGLAZE® be applied in two lighter coats rather than one
heavy coat. This ensures more uniform coverage. Allow one to two hours between
coats to ensure that material has properly dried (these times may vary depending on
ambient and substrate conditions).
LIMITATIONS
FABRIGLAZE® should not be applied to surfaces which have been wet or rained on
during any of the four preceding days or if rain is expected within four hours
following application. It is imperative that surfaces to be treated are thoroughly dry
and that they will not be subject to moisture ingress from below. FABRIGLAZE® is
not intended for use on heavy-duty floors. Consult the manufacturer for suitable
product selection.
The surface and ambient temperatures should be a minimum of 40°F (4°C) and
expected to remain so for at least twelve (12) hours following installation. Do not
apply FABRIGLAZE® if temperatures are above 80°F (27°C). Do not allow
FABRIGLAZE® to reach surfaces which can be damaged by petroleum solvents.
Protect all surrounding surfaces such as aluminum, glass, and porcelain or clean off
within ten (10) minutes of application.